Introduction

1. Owners Manual For Mac G5 Plus
2. Owners Manual For Mac G5 2017
3. Owners Manual For Mac G5 Pro
4. Owners Manual For Mac G5 Download

• Phillips #1 Screwdriver
• T10 Torx Screwdriver
• T15 Torx Screwdriver

No parts specified.

Owners Manual For Mac G5 Plus

• Place your g5 on a suitable surface

• Take out the power lead

• Prepare two screw drivers; T10 and Phillips (T15 may be used in some instances)

• Open the case by pulling the lock

• Take out the plastic cover

• Remove the major fan located on the left side of the processor

• Locate a small fan containing a speaker on the upper left corner of the motherboard.

• Pull it carefully

• There are two connections, which are needed to be disconnected (second image)

• Remove the graphics card

• Remove RAM

• Step 5 is about removing the cover which protects the processor from any outside damage

• The cover is attached to four pins. In order to remove the cover, it has to be pulled towards the left.

• : There may be a plastic (rubber) pin (see Image 2), which was put in place for guarantee purposes, therefore before sliding the panel, you should locate and remove this pin

• It can also be pushed from the inside (by lifting the bottom of the cover first) (see image 3)

• The next two steps will demonstrate how to remove the processor

• It should look like this (image 1) when the cover has been removed.

• Remove 8 screws shown on Image 2 and 3 (use T10 and T15 screw drivers)

• The processor should now come out

• Disconnect the cable connected to the processor

• Locate the side fan (right wall), push the pins and pull the fan

• Disconnect the fan cable (red square) and the rest of yellows if possible

• Unscrew two phillips screws located on the bottom power supply cover

• Remove the bottom screws which held the processor in place (four in total). This will help to take the cover out without damaging the motherboard

• The cover should now come out. It will require some bending and pay attention to the motherboard while performing this task.

• Remove the connectors (as shown on image 2 and 3)

• Locate four phillips screws on the bottom of the g5

• Remove them and pull the Power Supply.

• Disconnect the connector from the power supply (image 3, hdd lead)

• Remove Red and Yellow marked screws

• The Red are small black screws shown on the second image

• The processor holding screws are marked as yellow and have to be removed

• Green- pins which hold the motherboard in place

• In order to remove the motherboard, pull it (as shown on the third image) It should now slide on the pins which are marked as green.

• The motherboard should now come out freely

• Hope you enjoyed it, Michal Scrumpymacs

Power Mac G5 Take Apart 57 Speaker/Fan Assembly Tools The only tools required for this procedure are a Phillips screwdriver and needlenose pliers. Preliminary Steps Before you begin, open the computer, lay it on its side with the access side facing up, and remove the PCI card guide. Part Location. Load more results. Apple Footer Apple Support. Power Mac G5 (A1047) This is an official Powerbookmedic.com take-apart manual for the Power Mac G5 with model number A1047. Introduction 2. View and Download Apple Power Mac G5 user manual online. Apple Computer Desktop PC User's Guide Power Mac G5. Power Mac G5 Desktop pdf manual download. Also for: Power mac g5 (early 2005, Power mac g5 (late 2004.

Owners Manual For Mac G5 2017

To reassemble your device, follow these instructions in reverse order.

To reassemble your device, follow these instructions in reverse order.

Owners Manual For Mac G5 Pro

41 other people completed this guide.

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

Owners Manual For Mac G5 Download

Find End User Software License Agreements and Hardware Warranties.